New Grips

[Amber Lamps]

Originally Posted by itgirl

i dig 'em tigger.

Thank you sweetie! You know I gaze at your pics almost every night.

[Amber Lamps]

Originally Posted by TYEster

Not sure I'd rock the hard part around the thumb n index finger. What do you do if caught in the wet? Is the rest of the grip plastic, knurled metal or rubber?

?Black part is aluminum and the white is a special rubber compound.

http://www.drivenracing.com/content.cfm/go/gallery

[itgirl]

Originally Posted by TIGGER

Thank you sweetie! You know I gaze at your pics almost every night.

well, thank you.

[derf]

Again, other than looking good is here anything special about them that the aluminum rings do?

[Amber Lamps]

Originally Posted by derf

Again, other than looking good is here anything special about them that the aluminum rings do?

Hey I posted the site.... Okay lazy, they are designed to relieve hand stress and prevent arm pump. I've only put about 50 miles on them so far but I'm taking them out today for a long rideand I'll let you know. I had Oury grips on there before so they have a tough act to follow, imho.

[derf]

I thought Oury was for bycicles? In any case they are confy as hell, I had a pair on my last BMX bike

[Amber Lamps]

Originally Posted by derf

I thought Oury was for bycicles? In any case they are confy as hell, I had a pair on my last BMX bike

Nope they make MC grips, I've been using them for years....cheap too, about $9 a set.

[CrazyKell]

I like 'em.

I've had 2 sets of grips on my bike and I've hated both of them. I originally changed them because one side got pulled up in transport (canyon dancer issue).

The set I have on now is just a bit too short and there are gaps.....it drives me mental every single time I look at 'em.

Looking good Tig!

[CrazyKell]

Love the look of those.

How do I know I won't have the same problem as I've had with other grips (space left)?

[Amber Lamps]

Originally Posted by CrazyKell

Love the look of those.

How do I know I won't have the same problem as I've had with other grips (space left)?

Space? Well, on the throttle side you obviously want there to be a gap so your throttle can return smoothly. The thing is you can slide your housing in and out to adjust how much bar sticks out of the end...



Under the engine stop switch, there are phillips head screws that causes the housing to clamp down on the bar. All you need to do is loosen one of them enough to slide the housing where ever you need it to be.

Here's a breakdown,

http://fiche.ronayers.com/Index.cfm/...HANDLE_SWITCH_

Hope this helps!