Go Back   Two Wheel Fix > General > Cage Hell > Cage Tech

Reply
 
Thread Tools Display Modes
Old 09-26-2009, 08:25 PM   #1
Tsunami
Pug Queen
 
Tsunami's Avatar
 
Join Date: Dec 2008
Location: Las Vegas, NV
Moto: DR200, SV650
Posts: 2,486
Default

Quote:
Originally Posted by BobTheBiker View Post
let me ask something simple, that nobody else has. do you have a check engine light on the dash lit up? if so, have autozone pull the codes and see whats going on. THEN fix the problem rather than grasp at straws.
No check engine light.
Tsunami is offline   Reply With Quote
Old 09-26-2009, 08:38 PM   #2
BobTheBiker
too much time on my hands
 
BobTheBiker's Avatar
 
Join Date: Jul 2008
Location: the northern district of god damn
Moto: 01 ZX6R, looking for more now.
Posts: 1,802
Default

Might not hurt to clean the trottle body, and do a fuel filter. my aunts kia sportage does this at idle too, although I just dont give a shit cause tht thing leaks oil and needs 4X more work than its worth.
BobTheBiker is offline   Reply With Quote
Old 09-26-2009, 08:49 PM   #3
Amber Lamps
Moto GP Star
 
Join Date: Mar 2008
Posts: 14,556
Default

I still like the vac lines or the fuel filter.
Amber Lamps is offline   Reply With Quote
Old 09-26-2009, 10:37 PM   #4
derf
token jewboy
 
derf's Avatar
 
Join Date: Nov 2008
Moto: CBR 900, KLR ugly ass duckling, Gas Man
Posts: 10,799
Default

Quote:
Originally Posted by TIGGER View Post
I still like the vac lines or the fuel filter.
I just fixed my focus for a similar issue, eventually I found 2 vaccum leaks, one vac line wad a solid hole, because the tube was dry rotted and cracked, replaced that, but then the studder was still there randomly, eventually I was able to find that the valve cover breather was off the valve cover and enough gook had settled on the vac line to make it rub and wore through, but the grease was caked on thick enough that it would seal the vac line causing it to be an intermittent problem.
__________________
derf is offline   Reply With Quote
Old 09-26-2009, 10:55 PM   #5
Amber Lamps
Moto GP Star
 
Join Date: Mar 2008
Posts: 14,556
Default

Quote:
Originally Posted by derf View Post
I just fixed my focus for a similar issue, eventually I found 2 vaccum leaks, one vac line wad a solid hole, because the tube was dry rotted and cracked, replaced that, but then the studder was still there randomly, eventually I was able to find that the valve cover breather was off the valve cover and enough gook had settled on the vac line to make it rub and wore through, but the grease was caked on thick enough that it would seal the vac line causing it to be an intermittent problem.

That's where I'm at myself.
Amber Lamps is offline   Reply With Quote
Old 09-26-2009, 08:52 PM   #6
Flexin
AMA Supersport
 
Flexin's Avatar
 
Join Date: Nov 2008
Location: Halifax, Nova Scotia
Posts: 2,698
Default

Where is the mass air flow sensor on this car? If its near the air box I would check for the intake pipe after the sensor. Look for cracks or breaks in the pipe. This will allow air in that isn't measured by the mass air flow sensor which would cause it to act up. In some gears it could remain closed and cause no problems. In the lower gears you can have a lot of movement with the engine, this can cause a break to open up and let in more air.

James
__________________
"Bust a nut inside your eye, to show you where I come from"
"f youre horny, lets do it, Ride it, my pony, My saddles waitin, Come and jump on it, If youre horny, lets do it"
"I'm not a playa I just fuck a lot"
"Round two, I'm down to Do, what it takes to make you
Understand I'm the Candyman And I melt in your mouth, not in your hands Hard as rock, yes I'm no sucka The boots I knock make me one bad mutha"
Flexin is offline   Reply With Quote
Old 06-07-2010, 10:12 PM   #7
Tsunami
Pug Queen
 
Tsunami's Avatar
 
Join Date: Dec 2008
Location: Las Vegas, NV
Moto: DR200, SV650
Posts: 2,486
Default

I'm stalling doing chemistry hw so I am digging up old posts

Problem has been fixed. A fellow rider out here is a mechanic and fixed it.

Found out new wires weren't put in last time.

So he changed the plugs with NGK, wires, cap, ignition roter and fuel filter. He doesn't think the fuel filter's even been changed
Tsunami is offline   Reply With Quote
Old 06-08-2010, 02:28 AM   #8
101lifts2
WSB Champion
 
101lifts2's Avatar
 
Join Date: Nov 2008
Location: Anaheim, CA
Moto: 2009 Kawi ZX6R
Posts: 5,570
Default

Quote:
Originally Posted by Tsunami View Post
I'm stalling doing chemistry hw so I am digging up old posts

Problem has been fixed. A fellow rider out here is a mechanic and fixed it.

Found out new wires weren't put in last time.

So he changed the plugs with NGK, wires, cap, ignition roter and fuel filter. He doesn't think the fuel filter's even been changed
A wire trick is to spray them down with Windex and run the engine with the hood open and look for sparking.

Just make sure the valve cover isn't full of oil.
__________________
Train Hard

Ron Paul - 2012

Mark of Excellence
GM
101lifts2 is offline   Reply With Quote
Old 06-12-2010, 03:54 PM   #9
racedoll
AMA Supersport
 
Join Date: Nov 2008
Moto: '04 Kawasaki ZX6RR
Posts: 3,392
Default

Quote:
Originally Posted by azoomm View Post
Knowing Gina, and Puggy, you are.
Yep, exactly what I was thinking.

Glad you got your car fixed. Now go to your chemistry!
racedoll is offline   Reply With Quote
Old 06-08-2010, 12:06 AM   #10
Rangerscott
Viff6N Mutated Warrior
 
Rangerscott's Avatar
 
Join Date: Mar 2009
Location: Texas
Moto: '01 Honda VFR 800 & '09 ER-6N
Posts: 8,704
Default

Might as well change the air filter too.




P.S. You gotta change your avatar. I feel as if I'm really talking to your pug.
Rangerscott is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:34 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.